david 
One of the applience that you can fit in your home with ease is the heat pump. Due to the fact that a heat pump provides heat does not mean that the pump uses a lot of electric power. Air to air systems, geothermal heat pump and water source are some of the air conditioners that are used at home. They are not only used for heating but also, they are used as centered air conditions facilities that convert the warm heat into the more cooling air during high temperatures. A heat pump can be easily installed at home successively by following the easy steps and not damaging any part of the heat pump. By the use of the right appliance in installing a heat pump it will always be of much importance since the performance of the heat pump will not be compromised.
It is important to note that the heat pump should be placed a few inches away from the wall. Putting ventilation in mind it is important to note that the for proper ventilation, the vent should be situated some inches always from the wall. In a condition where there lack proper air flow there is a high possibility of fire breakage; therefore the clearance for ventilation is very vital. Materials that are prone to fire should be avoided when installing a heat pump.
Let’s look at placing. A the heat pump should be placed anywhere outside the house. Slab should be used to build the place at which the pump will be placed on while gravel should be used to construct the surroundings of the area where the heat pump will be set. Due to the vibrations caused by the heat pump when it is operating is the reason as to why it is situated outside. it is necessary to put in place two handles inside the home. It is advisable that the distance should be less than 15 feet, if not so then the filter wire should not be that high. The Padding is very crucial. Hence the dimension should be one and a half inch.
Some of the pumps are placed on rooftops therefor it is essential to put in consideration that the pump need anchoring. To do so use isolators as the anchoring tools for the pump with the roof. it is vital to make sure that the roof curb is at level and can hold the pump.
It is essential to note that to connect the inside unit to the outside unit you must use copper. Always use copper tuning for the valve cap of the pump and make sure that the valve cap is tight and well-sealed.